Changes

=== '''Fabric Care''' ===

===Fabric Care===

The beautiful fabric of your Zip Dee awning is made of acrylic fibers which cannot rot or mildew. Your awning can  be rolled  up wet  if necessary, but  be sure to open it  up to dry as soon as possible.

The beautiful fabric of your Zip Dee awning is made of acrylic fibers which cannot rot or mildew. Your awning can  be rolled  up wet  if necessary, but  be sure to open it  up to dry as soon as possible.

Any fabric can be punctured or tom by sharp edges that  scrape  or rub  against  it.  In installations  where  this contact  occurs,  be sure  to  install the  Zip  Dee door  roller  at  the top outer corner  of  the door  to  prevent awning  damage.  The rollers  are  inexpensive and will not be noticed on the door.

Any fabric can be punctured or tom by sharp edges that  scrape  or rub  against  it.  In installations  where  this contact  occurs,  be sure  to  install the  Zip  Dee door  roller  at  the top outer corner  of  the door  to  prevent awning  damage.  The rollers  are  inexpensive and will not be noticed on the door.

=== '''Washing''' ===

===Washing===

On a monthly basis, loosen hardened dirt and dust with a dry, medium bristle brush, then thoroughly rinse both top and bottom with a hose. For more  stubborn stains,  use  a  mild solution of 1/2 cup Chlorox bleach and 1/2 cup of Ivory Flakes diluted in one  gallon  of lukewarm water.

On a monthly basis, loosen hardened dirt and dust with a dry, medium bristle brush, then thoroughly rinse both top and bottom with a hose. For more  stubborn stains,  use  a  mild solution of 1/2 cup Chlorox bleach and 1/2 cup of Ivory Flakes diluted in one  gallon  of lukewarm water.

CAUTION: Never use a strong detergent or stain remover such as 409 or Fantastic on your awning. These can destroy the water repellency of the fabric.

CAUTION: Never use a strong detergent or stain remover such as 409 or Fantastic on your awning. These can destroy the water repellency of the fabric.

=== Water Leaks ===

===Water Leaks===

If leaking occurs after washing, it is usually the result of insufficient rinsing. If water drips through the needle holes in the stitching, you can use a commercial  seam sealer  available in canvas and trailer supply stores. You may also apply paraffin wax to the top of  the  seams. However, as the awning "weathers," these holes will normally seal themselves.

If leaking occurs after washing, it is usually the result of insufficient rinsing. If water drips through the needle holes in the stitching, you can use a commercial  seam sealer  available in canvas and trailer supply stores. You may also apply paraffin wax to the top of  the  seams. However, as the awning "weathers," these holes will normally seal themselves.

It is normal for slight leakage to occur through the fabric where water is allowed to accumulate or "pocket" on the fabric. See "Storm Precautions" for information on awning settings for proper water drainage. Sometimes soap or chemical residue, such as from active agents in insect fogs or sprays, can "wet" the fabric so that it appears unable to repel water. Rinse the fabric thoroughly and test for water repellency after it dries. If leakage continues, repeat the washing and thoroughly rinse.

It is normal for slight leakage to occur through the fabric where water is allowed to accumulate or "pocket" on the fabric. See "Storm Precautions" for information on awning settings for proper water drainage. Sometimes soap or chemical residue, such as from active agents in insect fogs or sprays, can "wet" the fabric so that it appears unable to repel water. Rinse the fabric thoroughly and test for water repellency after it dries. If leakage continues, repeat the washing and thoroughly rinse.

=== Storm Precautions ===

===Storm Precautions===

Because there is '''no warranty for damage caused by acts of God,''' steps should be taken to prevent damage from occurring due to wind, rain or storm.

Because there is '''no warranty for damage caused by acts of God,''' steps should be taken to prevent damage from occurring due to wind, rain or storm.

Water weighs nine pounds per gallon and your awning was not made to hold the 500 to 700 pounds that could accumulate. Since it only takes a few minutes to be completely safe, don't subject your awning and your coach to needless strain.

Water weighs nine pounds per gallon and your awning was not made to hold the 500 to 700 pounds that could accumulate. Since it only takes a few minutes to be completely safe, don't subject your awning and your coach to needless strain.

=== Hardware and Mechanism Maintenance ===

===Hardware and Mechanism Maintenance===

Although your Zip Dee awning requires less maintenance than any other awning,  a little care (about the same amount that you give to your coach) will keep the metal parts in top shape. The rafter arm assemblies, main arm tubes, and the awning case are bright-anodized aluminum; the castings are polished, high-strength aluminum alloys. To keep these parts new looking they should be cleaned once a year with a good quality non-abrasive chrome or aluminum polish.

Although your Zip Dee awning requires less maintenance than any other awning,  a little care (about the same amount that you give to your coach) will keep the metal parts in top shape. The rafter arm assemblies, main arm tubes, and the awning case are bright-anodized aluminum; the castings are polished, high-strength aluminum alloys. To keep these parts new looking they should be cleaned once a year with a good quality non-abrasive chrome or aluminum polish.

At the end of each season:

At the end of each season:

* Tighten any loose bolts or screws (Replace missing parts only with factory authorized replacements).

*Tighten any loose bolts or screws (Replace missing parts only with factory authorized replacements).

* Clean accessible hardware with non-abrasive cleaner.

*Clean accessible hardware with non-abrasive cleaner.

* Use a silicone lubricant only on the 1/2" round shafts that protrude from each end of the roller.

*Use a silicone lubricant only on the 1/2" round shafts that protrude from each end of the roller.

* Extend all telescoping arms as far as possible to wipe off accumulated sand and dirt tliat can clog and scratch the protective aluminum finish. No lubrication is required on those parts.

*Extend all telescoping arms as far as possible to wipe off accumulated sand and dirt tliat can clog and scratch the protective aluminum finish. No lubrication is required on those parts.

<br />

<br />

=== Replacement Parts ===

===Replacement Parts===

Use only genuine Zip Dee replacements parts when repairs are needed. Use of substitutes may damage your awning or void your warranty. Parts may be ordered through your local Zip Dee dealer. If you need help, we are as close as your telephone or post office. Use the number and description found on the parts list in this booklet when ordering parts and be sure to include the make, model and year of  your vehicle.  Warranty  claims must include the damaged part. If you cannot remove the damaged parts without a replacement, you must purchase the part at full price and receive a refund (if the warranty• applies)  when  we get the damaged part back. '''Take a''' moment '''to copy your hardware''' serial '''number and hardware code number from your front main arm tube into the cover of this manual.'''

Use only genuine Zip Dee replacements parts when repairs are needed. Use of substitutes may damage your awning or void your warranty. Parts may be ordered through your local Zip Dee dealer. If you need help, we are as close as your telephone or post office. Use the number and description found on the parts list in this booklet when ordering parts and be sure to include the make, model and year of  your vehicle.  Warranty  claims must include the damaged part. If you cannot remove the damaged parts without a replacement, you must purchase the part at full price and receive a refund (if the warranty• applies)  when  we get the damaged part back. '''Take a''' moment '''to copy your hardware''' serial '''number and hardware code number from your front main arm tube into the cover of this manual.'''

<br />

<br />

* ''Your warranty has limitations, so please read it carefully. Since warranty claims are honored only for registered original owners, '''mail -your- registration card today.'''''

*''Your warranty has limitations, so please read it carefully. Since warranty claims are honored only for registered original owners, '''mail -your- registration card today.'''''

<br />

<br />

== Custom Contour Awning Operation ==

==Custom Contour Awning Operation==

[[File:Zip Dee Custom Contour Awning Operation.png|right|frameless|622x622px]]

[[File:Zip Dee Custom Contour Awning Operation.png|right|frameless|622x622px]]

=== Opening your Awning ===

===Opening your Awning===

# Insert the pull rod into the Z-lock lever and pull downward. (Figure  1A) This releases the awning. Then turn the clamp wheel counterclockwise and swing the assembly toward the center to free the hardware. (Figure lB)

#Insert the pull rod into the Z-lock lever and pull downward. (Figure  1A) This releases the awning. Then turn the clamp wheel counterclockwise and swing the assembly toward the center to free the hardware. (Figure lB)

# Insert the pull  rod  into the loop of  the center control strap and  unroll the awning by pulling it toward you (Figure 2). Step under the awning and fold or roll  the control strap toward the backside of the roller and tuck under restraining strap.

#Insert the pull  rod  into the loop of  the center control strap and  unroll the awning by pulling it toward you (Figure 2). Step under the awning and fold or roll  the control strap toward the backside of the roller and tuck under restraining strap.

# '''APPLICABLE ONLY TO AVION AND GMC VEHICLES (OTHERS GO DIRECTLY TO STEP 4)''' Release the snap stud on the main arm (Figure 3)  and raise the awning until the second height hole is engaged.

#'''APPLICABLE ONLY TO AVION AND GMC VEHICLES (OTHERS GO DIRECTLY TO STEP 4)''' Release the snap stud on the main arm (Figure 3)  and raise the awning until the second height hole is engaged.

# Release the rafter arm by pulling outward  on the cap of the ratchet stud located on the upper portion of the arm. (Figure  4) Extend  the  arm and  place the claw over the shaft of the roller.

#Release the rafter arm by pulling outward  on the cap of the ratchet stud located on the upper portion of the arm. (Figure  4) Extend  the  arm and  place the claw over the shaft of the roller.

# Lock the rafter arm in position by pressing down on the steel main arm bar (Figure 5) until the ratchet stud clicks. At this point the fabric will be taut.

#Lock the rafter arm in position by pressing down on the steel main arm bar (Figure 5) until the ratchet stud clicks. At this point the fabric will be taut.

# Raise the awning to the desired height by releasing the snap stud  on the main  arm and pushing up and outward on the roller assembly (Figure 6).  Repeat steps 3-6 for the other end of the awning.

#Raise the awning to the desired height by releasing the snap stud  on the main  arm and pushing up and outward on the roller assembly (Figure 6).  Repeat steps 3-6 for the other end of the awning.

=== Partial Extension or "Caravan" Position ===

===Partial Extension or "Caravan" Position===

# Follow step 1 and 2 above.

#Follow step 1 and 2 above.

# Insert the pull rod in the loop of the center control strap and unroll the awning to the desired extension (Figure 7). Flip the Z-lock lever into the "closed" position to hold awning extended (Figure lA).

#Insert the pull rod in the loop of the center control strap and unroll the awning to the desired extension (Figure 7). Flip the Z-lock lever into the "closed" position to hold awning extended (Figure lA).

# To prevent billowing, hook the claw of the '''unextended''' rafter arm over the roller shaft (Figure 4). This will require that the awning to be extended approximately four and one half feet.

#To prevent billowing, hook the claw of the '''unextended''' rafter arm over the roller shaft (Figure 4). This will require that the awning to be extended approximately four and one half feet.

# '''Raise''' the awning to the desired height by following step 6 above.

#'''Raise''' the awning to the desired height by following step 6 above.

=== Closing your Awning ===

===Closing your Awning===

# Release the snap stud of the main arm and lower the awning.

#Release the snap stud of the main arm and lower the awning.

# Release the ratchet stud on  the rafter  arm  by pulling  outward  on the  cap.  Lift the claw from the roller shaft and place it on the height adjustment stud  located on  the inside of the main arm (Figure 16) page 10. This  allows  a "scissors-like" action  that helps guide the arm upward.

#Release the ratchet stud on  the rafter  arm  by pulling  outward  on the  cap.  Lift the claw from the roller shaft and place it on the height adjustment stud  located on  the inside of the main arm (Figure 16) page 10. This  allows  a "scissors-like" action  that helps guide the arm upward.

# Repeat steps 1 and 2 or the other end of the awning.

#Repeat steps 1 and 2 or the other end of the awning.

# Face the awning and hold the end of the control strap firmly in one hand then  push the roller up briskly with a rolling motion until you feel the spring take over. Control the speed by holding the control strap until all but 6 inches of the fabric has been rolled up. Release the strap and let the awning roll freely the rest of the way. This additional force will help tighten the fabric around the roller for the tightest, n.ax appearance.

#Face the awning and hold the end of the control strap firmly in one hand then  push the roller up briskly with a rolling motion until you feel the spring take over. Control the speed by holding the control strap until all but 6 inches of the fabric has been rolled up. Release the strap and let the awning roll freely the rest of the way. This additional force will help tighten the fabric around the roller for the tightest, n.ax appearance.

# Lock the awning in place by reversing steps 1 and 2 of  the  opening procedure Figures lA & 18).

#Lock the awning in place by reversing steps 1 and 2 of  the  opening procedure Figures lA & 18).

<br />

<br />